Audio
when radio signals are weak. When this
happens, perform manual tuning to select
the preferred station.
! Scan tuning (SCAN)
“SCAN” button:
audio)
Automatic tuning may not function properly if the station reception is weakened by
distance from the station or proximity to
tall buildings and hills.
! PTY (Program type) group tuning
(only FM reception) (type A audio)
Type A audio
does not change the station that is
currently being received.
! Seek in PTY (Program type) group
Seek up
Seek down
“PTY/CAT” button
Type B audio
If you press the “SCAN” button, the radio
will switch to the scan mode. In this mode,
the radio scans through the radio band
until a station is found. The radio will
briefly stop at the station while displaying
the frequency, after which scanning will
continue until the entire band has been
scanned.
Press the “SCAN” button again to cancel
the SCAN mode. If you press the “SCAN”
button while the radio is stopped at a
station, the radio stays stopped at that
station. If you press the button while the
radio is scanning, the radio stops as
follows.
. At a frequency when the “SCAN”
button is pressed (type A audio)
. At the next receivable station (type B
5-11
Press the “PTY/CAT” button to change to
the PTY selection mode. At this time, the
PTY group that you are currently listening
to will be displayed for 10 seconds. In PTY
selection mode, “PTY SEL” is displayed
on the screen.
In the PTY selection mode, when the
preferred PTY group has been selected,
pressing the “SEEK” button “ ” or “ ”
seeks within that PTY group. In this case,
“PTY SEEK” is displayed on the screen.
The control function returns to the normal
mode after approximately 10 seconds.
! PTY (Program type) group selection
In the PTY selection mode, press the
following button to change the PTY group
by one step at a time.
PTY group up by
one step
PTY group down by
one step
This operation only changes the display. It
– CONTINUED –