Subaru Outback Manuals 2013 Outback Owner's Manual | Page 171

Instruments and controls ! Gear position indicator setting (MT models) The gear position indicator light can be activated or deactivated by performing the following procedure. 1. Turn the ignition switch to the “LOCK”/ “OFF” position. 2. Press the trip knob to show “ ” or “ ” on the trip meter display. The display can be switched as shown in the following illustration by pressing the trip knob. NOTE . The initial setting for your vehicle of the gear position indicator has been set for activation “ ” at the time of shipment from the factory. . It is not possible to change the setting of the gear position indicator when the ignition switch is in the “ON” position. Change the setting when the ignition switch is in the “LOCK”/“OFF” or “Acc” position. & Turn signal indicator lights Type B 1) Upshift/downshift indicator (AT and CVT models) These lights show the operation of the turn signal or lane change signal. If the indicator lights do not blink or blink rapidly, the turn signal bulb may be burned out. Replace the bulb as soon as possible. Refer to “Replacing bulbs” F11-43. This indicator shows the position of the shift lever (MT models) or select lever (AT and CVT models). ! Upshift/downshift indicator (AT and CVT models)