Keys and doors
will flash once, and the security indicator
light will start flashing rapidly. After rapid
flashing for 30 seconds (standby time), the
security indicator light will then flash
slowly (twice approximately every 2 seconds), indicating that the system has been
armed for surveillance.
2-29
light will turn off.
To unlock all other doors and the rear gate
(Outback), briefly press the disarm button
a second time within 5 seconds.
& Disarming the system
1)
Door lock button
Security indicator light
6. Carry the access key and press the
door lock button. All doors (and the rear
gate) will lock, an electronic chirp will
sound once, the hazard warning flashers
If any of the doors or the rear gate is not
fully closed, an electronic chirp sounds
five times, the hazard warning flashers
flash five times to alert you that the doors
(or the rear gate) are not properly closed.
When you close the door, the system will
automatically arm and doors will automatically lock.
! Emergency disarming
If you cannot disarm the system using the
transmitter (i.e. the transmitter is lost,
broken or the transmitter battery is too
weak), you can disarm the system without
using the transmitter.
The system can be disarmed if you turn
the ignition switch from the “LOCK”/“OFF”
to the “ON” position with a registered key/
access key.
NOTE
Perform either of the following procedures.
. Briefly press the disarm button (for less
than 2 seconds) on the access key/remote
transmitter.
. Carry the access key and perform
either of the following procedures (models
with “keyless access with push-button
start system”).
– Grip the front door handle.
– Press the rear gate opener button.
For models with “keyless access with
push-button start system”, if the access key battery is discharged, perform
the procedure described in “Switching
power” F9-20. In such a case, replace
the battery immediately. Refer to “Replacing battery of access key” F11-54.
The driver’s door will unlock (or the rear
gate will open), an electronic chirp will
sound twice, the hazard warning flashers
will flash twice and the security indicator
& Valet mode
When you choose the valet mode, the
alarm system does not operate. In valet
mode, the access key/remote transmitter
is used only for locking and unlocking the
doors and rear gate (Outback) and panic
– CONTINUED –