Troubleshooting
Cruise control cannot be set.
Did you remember to press the
(CRUISE) switch?
If you have not pressed the
(CRUISE) switch, the
Control) indicator will not be shown.
(Adaptive Cruise
Is EyeSight operation temporarily stopped?
When EyeSight is temporarily stopped, the EyeSight temporary stop indicator light
illuminates and
is displayed on the multi information display.
Set cruise control again after the reason for the temporary stop has been corrected.
Is the [READY] indicator displayed?
When Adaptive Cruise Control is being used Cruise control cannot be set when
the [READY] indicator is not displayed. Set cruise control when the [READY] indicator is displayed.
The [READY] indicator is not displayed.
Have you selected Conventional Cruise Control?
With Conventional Cruise Control,
(following distance setting) will not be displayed on the multi information display.
Are the requirements for setting cruise control met?
In any of the following cases, the [READY] indicator will not be displayed.
The brake pedal is depressed.
The vehicle speed is over 90 MPH (145 km/h). (When no vehicle in front
has been detected, the speed is between approximately 25 MPH (40 km/h)
and 90 MPH (145 km/h).)
The combination meter indicates a position other than D . (The select
lever or paddle shift switches are manually operated.)
The driver’s seatbelt is unfastened.
Any door is opened (except the rear gate/trunk).
The electronic parking brake is applied (when
is illuminated or flashing)*.
The vehicle is on a steep grade.
Vehicle Dynamics Control is off, or is turned off.
*For details of how to release the Electronic Parking Brake, refer to the
Owner’s Manual for your vehicle.
78