Adaptive Cruise Control
To set ready status:
All of the following conditions must be met in order to set Adaptive Cruise Control.
- All doors are closed. (The rear gate/trunk should always be closed before the vehicle is
driven.)
- The driver’s seatbelt is fastened.
- The electronic parking brake is not engaged (
is off).
- The select lever is in the “D” position, and “D” is displayed on the combination meter.
- The brake pedal is not depressed.
- EyeSight operation is not temporarily stopped.
- The road is not a steep slope.
- The steering wheel has not been turned significantly in either direction.
- Vehicle Dynamics Control was not turned off.
- The vehicle speed is over approximately 25 MPH (40 km/h).
- The vehicle speed is approximately 25 MPH (40 km/h) or less and there is a vehicle in
front.
Press the RES/SET switch to the “SET/-”.
Adaptive Cruise Control is now set, and cruise
control will start.
The SET indicator on the multi information
display will now illuminate.
If no vehicle in front has been detected, the
vehicle drives at the constant set target
speed. (If cruise control is set while the vehicle is driving at approximately 25 MPH (40
km/h) or less, the set vehicle speed is autoS00628
matically set to 25 MPH (40 km/h).)
S00557
*Models for Canada: Metric units are used.
26