Maintenance and service
11-51
& Tail/Back-up light (Outback)
1)
2)
3)
Tail and rear side marker light
Brake light
Rear turn signal light
5. Remove the bulb holder from the rear
combination light assembly by turning it
counterclockwise.
6. Pull the bulb out of the bulb holder and
replace it with a new one.
7. Set the bulb holder into the rear
combination light assembly and turn it
clockwise until it locks.
8. Reinstall the rear combination light
assembly by sliding the two-pronged part
of the combination light assembly securely
to each holder of the vehicle side.
1. Apply a flat-head screwdriver to the
light cover as shown in the illustration, and
pry the light cover off from the rear gate
trim.
9. Tighten the upper and lower screws.
10. Reinstall the side cover.
– CONTINUED –