Subaru Outback Manuals 2012 Outback Owner's Manual | Page 307

Starting and operating again, turn the ignition switch to the “LOCK” position and restart the en- gine. . When the switch is pressed to deactivate the Vehicle Dynamics Con- trol system, the vehicle’s running per- formance is comparable with that of a vehicle that does not have a Vehicle Dynamics Control system. Do not de- activate the Vehicle Dynamics Control system except when absolutely neces- sary. . Even when the Vehicle Dynamics Control system is deactivated, compo- nents of the brake control system may still activate. When the brake control system is activated, the Vehicle Dy- namics Control operation indicator light illuminates. Tire pressure monitoring system (TPMS) (if equipped) The tire pressure monitoring system pro- vides the driver with a warning message by sending a signal from a sensor that is installed in each wheel when tire pressure is severely low. The tire pressure monitoring system will activate only when the vehicle is driven at speeds above 20 mph (32 km/h). Also, this system may not react immediately to a sudden drop in tire pressure (for example, a blow-out caused by running over a sharp object). 7-29 WARNING If the low tire pressure warning light illuminates while driving, never brake suddenly and keep driving straight ahead while gradually redu- cing speed. Then slowly pull off the road to a safe place. Otherwise an accident involving serious vehicle damage and serious personal injury could occur. Check the pressure for all four tires and adjust the pressure to the COLD tire pressure shown on the tire placard on the door pillar on the driver’s side. Even when the vehicle is driven a very short distance, the tires get warm and their pressures increase accordingly. Be sure to let the tires cool thoroughly before adjusting their pressures to the standard values shown on the tire placard. Refer to “Tires and wheels” F11-30. The tire pressure monitoring system does not function when the vehicle is stationary. After adjusting the tire pressures, increase the vehicle speed to at least 20 mph (32 km/h) to start the TPMS re-checking of the tire inflation pressures. If the tire pressures are now above the severe – CONTINUED –