Subaru Outback Manuals 2012 Outback Owner's Manual | Page 136

3-16 Instruments and controls ally reducing speed. Then slowly pull off the road to a safe place. Otherwise an accident involving serious vehicle damage and serious personal injury could occur. If this light still illuminates while driving after adjusting the tire pres- sure, a tire may have significant damage and a fast leak that causes the tire to lose air rapidly. If you have a flat tire, replace it with a spare tire as soon as possible. When a spare tire is mounted or a wheel rim is replaced without the original pressure sensor/transmitter being transferred, the Low tire pres- sure warning light will illuminate steadily after blinking for approxi- mately one minute. This indicates the TPMS is unable to monitor all four road wheels. Contact your SUBARU dealer as soon as possible for tire and sensor replacement and/ or system resetting. If the light illuminates steadily after blinking for approximately one minute, promptly contact a SUBARU dealer to have the system inspected. CAUTION The tire pressure monitoring system is NOT a substitute for manually checking tire pressure. The tire pressure should be checked peri- odically (at least monthly) using a tire gauge. After any change to tire pressure(s), the tire pressure mon- itoring system will not re-check tire inflation pressures until the vehicle is first driven more than 20 mph (32 km/h). After adjusting the tire pres- sures, increase the vehicle speed to at least 20 mph (32 km/h) to start the TPMS re-checking of the tire infla- tion pressures. If the tire pressures are now above the severe low pressure threshold, the low tire pressure warning light should turn off a few minutes later. Therefore, be sure to install the specified size for the front and rear tires. & ABS warning light CAUTION . If any of the following conditions occur, we recommend that you have the ABS system repaired at the first available opportunity by your SUBARU dealer. – The warning light does not illuminate when the ignition switch is turned to the “ON” position. – The warning light illuminates when the ignition switch is turned to the “ON” position, but it does not turn off even when the vehicle speed ex- ceeds approximately 12 km/h (8 mph). – The warning light illuminates during driving. – The warning light flashes. . When the warning light is on (and brake system warning light is off), the ABS function shuts down; however, the conventional brake system continues to oper- ate normally. . When the warning light is flash- ing, the ABS system may be malfunctioning. However, the conventional brake system con- tinues to operate normally. The ABS warning light illuminates to- gether with the brake system warning light if the EBD system malfunctions. For further details of the EBD system mal-