Audio
CAUTION
. Do not leave the cell phone in the
vehicle. The temperature in the
vehicle may become extremely
high and cause a malfunction of
the cell phone.
. When using the cell phone, be
careful not to get it close to the
in-vehicle equipment. Getting it
too close to the in-vehicle equipment may result in deterioration
in tone quality or a poor connecting condition.
. In the frequency band used by
this equipment, along with industrial, scientific and medical
equipment such as a microwave
oven, radio stations (a license is
required) to be used by the
production line in the factory to
identify movable bodies, specific
small power radio stations (a
license is not required) and amateur radio stations (a license is
required) are being operated.
(These three types of radio stations are hereinafter referred to
as “other radio stations”.) Before
using this equipment, be sure to
check to see if “other radio
stations” are being operated in
the vicinity. If there is detrimental
radio interference from this
equipment to “other radio stations”, move the equipment to
another location as soon as
possible to avoid radio interference. The frequency band used
by this equipment is in the 2.4
GHz zone. The FH-SS modulation
is employed as a modulation
method. The expected inflicting
interference distance is less than
33 ft (10 m). This equipment uses
a full band and can avoid a band
used by a movable body identification device.
5-35
& Using the Hands-free system
! Turning on/off the Hands-free mode
1)
2)
OFF hook switch
ON hook switch
To turn on the Hands-free mode, press the
OFF hook switch
. To turn off the
Hands-free mode, press the ON hook
switch
.
! Preparation for using the Handsfree system
Before using the Hands-free system, it is
necessary to register a cell phone in the
system. Perform the following procedure
to register a cell phone.
.
1. Press the OFF hook switch
2. Select “Set up” by operating the
“TUNE/TRACK/CH” dial.
– CONTINUED –