456
Loading Your Vehicle
hazard .
. Do not install a roof tent on the vehicle . Doing so may damage the vehicle and create a safety hazard . SUBARU warranties do not cover vehicle damage resulting from use of a roof tent .
Cargo can be carried after securing the roof crossbar kit to the roof molding and installing the appropriate carrying attachment . When installing the roof crossbar kit , follow the manufacturer ’ s instructions .
When carrying cargo on the roof using the roof crossbar kit and carrying attachments , never exceed the maximum load limit as explained below . You should also be careful that the vehicle does not exceed the Gross Vehicle Weight Rating ( GVWR ) and front and rear Gross Axle Weight Rating ( GAWR ). For information about loading cargo into or onto your vehicle , refer to “ Loading Your Vehicle ” FP453 . The maximum total load on the roof ( including crossbars , carrying attachments and cargo ) must not exceed 88 lbs ( 40 kg ). Refer to the crossbar installation instructions for the maximum crossbar capacity . Place the heaviest load at the bottom , close to the roof , and evenly distribute the cargo . Always properly secure all cargo .
! Installing carrying attachments on the crossbars s08aj0601
When installing any carrying attachments such as the load carriers , crossbars , bike carrier , ski carrier , kayak carrier , cargo basket , etc ., follow the manufacturer ’ s instructions for the load capacity and make sure that the attachments are securely installed . Use only attachments designed specifically for the crossbars . Before operating the vehicle , make sure that the cargo is properly secured on the attachment .
NOTE
Remember that the vehicle ’ s center of gravity is altered with the weight of the load on the roof , thus affecting the driving characteristics .
Drive carefully . Avoid rapid starts , hard cornering and abrupt stops . Crosswind effects will be increased .
! Removal and installation of the crossbars s08aj0602
Each of the two roof moldings has two mounting points for crossbars . Each mounting point is fitted with a cover . Use a screwdriver to open the covers . When installing the crossbars on the roof molding , follow the manufacturer ’ s instructions .