356
Starting and Stopping the Engine ( Models without Push-Button Ignition Switch )
7-4 . Starting and Stopping the Engine ( Models without Push-Button Ignition Switch )
s07bd
& General Precautions When Starting / Stopping Engine s07bd06
WARNING
. Never start the engine from outside the vehicle ( except when using the remote engine start system ). It may result in an accident .
. Do not leave the engine running in locations with poor ventilation , such as a garage and indoors . The exhaust gas may enter the vehicle or indoors , and it may result in carbon monoxide poisoning .
. Do not start the engine near dry foliage , paper , or other flammable substances . The exhaust pipe and exhaust emissions can create a fire hazard at high temperatures .
CAUTION
. If the engine is stopped during driving , the catalyst may overheat and burn .
. When starting the engine , be sure to sit in the driver ’ s seat ( except when using the remote engine start system ).
NOTE
. Avoid racing and rapid acceleration immediately after the engine has started . . After the engine starts , the engine speed will be kept high . . On rare occasions , it may be difficult to start the engine depending on the fuel used and the driving condition ( repeated short trips when the engine is not warmed up sufficiently ). In such a case , it is recommended to switch to a different brand of fuel . . On rare occasions , transient knocking may be heard from the engine when the accelerator is operated rapidly such as a rapid start-up and a rapid acceleration . This is not a malfunction .
. The engine starts more easily when the headlights , air conditioner and rear window defogger are turned off .
& Starting Engine
CAUTION s07bd01
Do not operate the starter motor continuously for more than 10 seconds . If the engine fails to start after operating the starter for 5 to 10 seconds , wait for 10 seconds or more before trying again .
NOTE
. It may be difficult to start the engine when the battery has been disconnected and reconnected ( for maintenance or other purposes ). This difficulty is caused by the electronically controlled throttle ’ s self-diagnosis function . To overcome it , keep the ignition switch in the “ ON ” position for approximately 10 seconds before starting the engine . . Do not shift the select lever while the starter is cranking .