266
Turn Signal Lever
3-15 . Turn Signal Lever
1 ) |
Right turn |
2 ) |
Lane change right signal |
3 ) |
Lane change left signal |
4 ) |
Left turn |
s03ai
If the lever does not return after cornering , return the lever to the neutral position by hand .
To signal a lane change , push the turn signal lever up or down slightly and hold it during the lane change . The lever will return automatically to the neutral position when you release it .
& One-Touch Lane Changer s03ai01
To flash the turn signal and turn signal indicator light three times , push the turn signal lever up or down slightly and immediately release it .
NOTE
The operational / non-operational setting of the one-touch lane changer can be changed by a SUBARU dealer . Contact the nearest SUBARU dealer for details . The setting can also be changed by operating the center information display . For details , refer to “ Car settings ” FP226 ( 11.6-inch display models ) or “ Vehicle setting icons ” FP246 ( dual 7.0-inch display models ).
3-16 . Wiper and Washer
WARNING s03am
In freezing weather , do not use the windshield washer until the windshield is sufficiently warmed by the defroster .
Otherwise the washer fluid can freeze on the windshield , blocking your view .
CAUTION
. Do not operate the washer continuously for more than 10 seconds , or when the washer fluid tank is empty . This may cause overheating of the washer motor . Check the washer fluid level frequently , such as at fuel stops .
. Do not operate the wipers when the windshield or rear window is dry . This may scratch the glass , damage the blade rubbers and might cause the wiper motor to fail . Before operating the wiper on a dry windshield or rear window , always use the windshield washer .