Instruments and controls/Mirrors
3-79
! Programming a New HomeLink ®
button
S03AP100301
1)
1)
2)
Indicator Light
HomeLink ® buttons
1. Press and release the HomeLink ®
button that you would like to program.
The HomeLink ® indicator light will flash
orange slowly (if not, refer to “Erasing
HomeLink ® buttons” F3-81).
Garage door opener remote
2. Position the hand-held remote (garage
door opener remote) 1 to 3 inches (2 to 8
cm) away from the HomeLink ® button that
you would like to program.
NOTE
Some hand-held remotes (garage door
opener remotes) may actually train
better at a distance of 6 to 12 inches
(15 to 30 cm). Keep this in mind if you
have difficulty with the programming
process.
3. While the HomeLink ® indicator light is
flashing orange, press and hold the hand-
held remote button. Continue pressing the
hand-held remote button until the
HomeLink ® indicator light changes from
orange to green. You may now release the
hand-held remote button.
NOTE
Some devices may require you to re-
place this “Programming a New
HomeLink ® button” step 3 with proce-
dures noted in the “Gate Operator /
Canadian Programming” section. Refer
to “Gate Operator / Canadian Program-
ming” F3-81.
– CONTINUED –