Subaru Legacy Manuals 2019 Legacy Owner's Manual | Page 209

Instruments and controls/Light control switch ! Malfunction of the high beam assist function S03AH0705 If the high beam assist function is mal- functioning or is temporarily stopped, the headlight will be fixed at low beam. High beam assist warning indicator (yel- low) When the high beam assist function malfunctions, the high beam assist warn- ing indicator on the combination meter will appear. In this case, have your vehicle inspected by your SUBARU dealer. ! Temporary stop of high beam assist function S03AH0706 If the high beam assist function stops temporarily due to poor visibility or abnor- mal temperature, the message appears on the combination meter. Once the condi- 3-53 tions have been remedied, drive the vehicle for a while to restore the system. NOTE Even when the operation conditions of the high beam assist function are met, there may be a case in which the high beam assist indicator does not illumi- nate. Type A: In this case, turn the ignition switch to the “LOCK”/“OFF” position and then to the “ON” position again. Check if the high beam assist indicator illuminates. If the indicator does not illuminate, have the vehicle inspected at a SUBARU dealer. Type B: For details, refer to the Owner’s Manual supplement for the EyeSight system. ! How to temporarily lower the sensi- tivity of the high beam assist func- tion S03AH0704 The sensitivity of the high beam assist function can be lowered by using the following operations. Type A: 1. Turn the ignition switch to the “ON” position. 1) Automatic dimming on/off button 2. Press and hold the automatic dimming on/off button for 15 to 20 seconds. When the sensitivity of the high beam assist function is lowered, the LED indi- cator on the automatic dimming on/off button will flash. NOTE . The sensitivity of the high beam assist function cannot be lowered while driving. . You can resume the sensitivity of the high beam assist function by using either of the following operations. – Turn the ignition switch to the “LOCK”/“OFF” position and then start the engine. – CONTINUED –