Instruments and controls/Light control switch
& High beam assist function (if
equipped)
may not operate properly.
S03AH07
& High/low beam change
(dimmer)
S03AH02
Type A
1) Camera for high beam assist function
To change from low beam to high beam,
push the turn signal lever forward. When
the headlights are on high beam, the high
beam indicator light “ ” on the combina-
tion meter is also on.
To switch back to low beam, pull the lever
back to the center position.
3-51
The high beam assist function automati-
cally changes the headlight between high
beam and low beam. When all of the
following conditions are met, the headlight
will change to high beam.
. When the vehicle speed increases to or
above 20 mph (32 km/h).
. There is no preceding vehicle.
. The forward area of the vehicle is dark.
. The road does not have a sharp curve.
When any of the following conditions is
met, the headlight will change to low beam.
. When the vehicle speed decreases to
or below 10 mph (16 km/h).
. When the forward area of the vehicle is
bright.
. When there is a preceding or oncoming
vehicle.
. When the EyeSight system is malfunc-
tioning or is temporarily stopped (Type B).
NOTE
Type B
1) Stereo camera for high beam assist
. The factory setting (default setting)
for this function is set as “operational”.
This setting can be changed to OFF
(non-operation) at SUBARU dealers.
For more details, contact a SUBARU
dealer.
. Do not overestimate the capacity of
the high beam assist function. The
driver always has the responsibility to
– CONTINUED –