In case of emergency/Access key fob – if access key fob does not operate properly
Access key fob – if access key
fob does not operate properly
& Locking and unlocking
9-19
& Switching power status
S09AP01
S09AP02
1. Apply the parking brake.
2. Shift the select lever into the “P”
position.
3. Depress the brake pedal.
S09AP
CAUTION
Keep metallic objects, magnetic
sources and signal transmitters
away from the area between the
access key fob and the push-button
ignition switch. They may interfere
with the communication between
the access key fob and the push-
button ignition switch.
The following functions may be inoperable
because of strong radio signals in the
surrounding area or a low battery condition
of the access key fob.
. Locking/unlocking doors including rear
gate
. Switching power status
. Starting engine
In such cases, perform the following
procedure. When the battery of the access
key fob is discharged, replace it with a new
one. Refer to “Replacing battery of access
key fob” F11-48.
1)
2)
Release button
Emergency key
While pressing the release button of the
access key fob, take out the emergency
key.
Lock or unlock the driver’s door with the
emergency key in the procedure described
in “Locking and unlocking from the out-
side” F2-6.
NOTE
After locking or unlocking, be sure to
attach the emergency key back to the
access key fob.
4. Hold the access key fob with the
buttons facing you, and touch the push-
button ignition switch with it.
When the communication between the
access key fob and the vehicle is com-
pleted, a chime (ding) will sound. At the
same time, the status of the push-button
ignition switch changes to either of the
following.
. When the keyless access with push-
button start system is deactivated:
“ACC”
. Under other conditions: “ON”
– CONTINUED –