2-12
Keys and doors/Keyless access with push-button start system
near wireless communication equip-
ment such as a cell phone, or near a
metallic object
. When metallic accessories are at-
tached to the access key fob
. When carrying the access key fob
with electronic appliances such as a
laptop computer
. When the battery of the access key
fob is discharged
In such cases, it may not be possible to
lock or unlock the doors or start the
engine.
! Regarding malfunction
S02AP1102
CAUTION
. Never leave or store the access
key fob inside the vehicle or
within 6.6 ft (2 m) around the
vehicle (e.g., in the garage). The
access key fob may be locked
inside the vehicle, or the battery
may discharge rapidly. Note that
the push-button ignition switch
may not turn on in some cases
depending on the location of the
access key fob.
. The access key fob contains
electronic components. Observe
the following precautions to pre-
vent malfunctions or battery dis-
charge.
– It is recommended to have the
access key battery replaced at
an authorized SUBARU dealer
to avoid the risk of damage.
– Do not get the access key fob
wet. If the access key fob gets
wet, wipe it off immediately
and let it dry completely.
– Do not apply strong impacts to
the access key fob.
– Keep the access key fob away
from magnetic sources.
– Do not leave the access key
fob near a personal computer
or home electrical appliance.
– Do not leave the access key
fob near a battery charger or
any electrical accessories.
– Do not apply metallic window
tint or attach metallic objects
to the windows.
– Do not fit non genuine acces-
sories and parts.
– Never leave the access key
fob in direct sunlight or any-
where that may become hot,
such as on the dashboard. It
may damage the battery or
cause circuit malfunctions.
– Do not wash the access key
fob in an ultrasonic washer.
– Do not leave the access key
fob in humid or dusty loca-
tions, or near personal com-
puters or home electric appli-
ances.
NOTE
After the vehicle battery is discharged
or replaced, initialization of the steering
lock system may be required to start
the engine. In this case, perform the
following procedure to initialize the
steering lock.
1) Turn the push-button ignition
switch to the “OFF” position. For de-
tails, refer to “Switching power status”
F3-7.
2) Open and close the driver’s door.
3) Wait for approximately 10 seconds.
When the steering is locked, the initi-
alization is completed.