2-20
Keys and doors/Keyless access with push–button start system
! By operating the driver’s door
1. Sit in the driver’s seat, and close the
door.
7. Within 10 seconds after step 6 is
performed, close and open the driver’s
door once.
8. Within 5 seconds after step 7 is
performed, close the door.
A chirp sound will be heard, and the
functions will be disabled.
NOTE
2. Push the rear side (unlock side) of the
power door locking switch.
3. Within 5 seconds after step 2 is
performed, open the driver’s door.
4. Within 5 seconds after step 3 is
performed, push the rear side (unlock
side) of the power door locking switch
twice while the door is open.
5. Within 10 seconds after step 4 is
performed, close and open the driver’s
door twice.
6. Within 10 seconds after step 5 is
performed, push the rear side (unlock
side) of the power door locking switch
twice while the door is open.
driver’s door: a chirp will not be
heard
– When disabling by operating the
access key: a chirp will be heard
& When access key does not
operate properly
Refer to “Access key – if access key does
not operate properly” F9-18.
In steps 4 and 6, press the power door
locking switch firmly. If the switch is
not pressed firmly, the functions may
not be disabled.
& Replacing battery of access
key
! Enabling functions
When the procedure to disable the functions is performed again, a chirp sound will
be heard, and the functions are enabled.
& Replacing access key
NOTE
. The keyless access function will be
enabled only if you perform the procedure in the same manner you disabled
the function (for example, when disabling by operating the driver’s door,
the function will not be enabled even if
you operate the access key).
. Press the push-button ignition
switch if you do not know the procedure in which the keyless access
function was disabled.
– When disabling by operating the
Refer to “Replacing battery of access key”
F11-50.
Access keys can be replaced at SUBARU
dealers. For more details, contact a
SUBARU dealer.