Keys and doors/Rear gate (Outback)
open.
! Memory function
NOTE
. The rear gate remains unlocked
even after closing it. Always lock the
rear gate when leaving the vehicle.
. If the rear gate cannot be opened/
closed by performing the operation
described above, a short electronic
chirp will sound three times (beep,
beep, beep).
! Manual operation
2-43
registered.
Registration of the rear gate height:
To register the rear gate height, perform
the following procedures while the ignition
switch is in the “LOCK”/“OFF” position.
1. Open the rear gate by using the power
rear gate function.
2. With the rear gate at the desired
height, stop it by using the power rear
gate function.
3. Press the memory switch to select the
“ON” status.
NOTE
Using the power rear gate operation is
recommended. Manual operation will
require physical effort.
The power rear gate can open and close
manually. Refer to “Manual rear gate” F2-
38.
Memory switch
Power rear gate button on the inside edge
of the rear gate
Memory switch status
1) ON status
2) OFF status
Your desired rear gate height can be
4. With the rear gate at the desired
height, press and hold the power rear
gate button on the inside edge of the rear
gate until an electronic chirp is heard and
CONTINUED