Subaru Legacy Manuals 2014 Legacy Owner's Manual | Page 66

Seat, seatbelt and SRS airbags/Front seats driver’s door is opened, the registered seat position can be retrieved even if the ignition switch is in the “LOCK” or “OFF” position. ! Retrieval of the seat position registered with access key 1. Hold the registered access key. 1. Turn the ignition switch to the “ON” position. 2. While the select lever is in the “P” position and the parking brake is applied, press button “1” or “2”. 3. The chirp sound sounds and the seat moves to the registered position. 4. When the seat moves to the registered position, the chirp sound sounds. NOTE . If a new position is registered for the same button, the previously registered seat position is deleted. . If the vehicle battery is removed, the registered seat position is not deleted. . When the button “1” or “2” is pressed within 45 seconds after the 2. Unlock the driver’s door by pressing the “ ” button or gripping the door handle. 3. Open the driver’s door. 4. The chirp sound sounds and the seat moves to the registered position. 5. When the seat moves to the registered position, the chirp sound sounds. 1-7 NOTE . If the registered seat position cannot be retrieved after performing the previous procedures, try the following procedures. (1) Press the “SET” button on the driver’s door. (2) Press the “ ” button on the access key or the door lock button to lock the doors. (3) Perform the prior procedures again. . If the keyless access function is disabled, the seat position cannot be retrieved by gripping the driver’s door handle. However, the seat position can still be retrieved by pressing the “ ” button on the access key. For information about how to enable/disable the keyless access function, refer to “Disabling keyless access function” F2-17. . If a new position is registered for the same access key, the previously registered seat position is deleted. ! Clearing the registered seat position with access key 1. Close the driver’s door. 2. While holding the access key and pressing the “SET” button, press the “ ” button on the access key. – CONTINUED –