5-48
Audio
by this equipment is in the 2.4
GHz zone. The FH-SS modulation
is employed as a modulation
method. The expected inflicting
interference distance is less than
33 ft (10 m). This equipment uses
a full band and can avoid a band
used by a movable body identification device.
Hands-free mode, press the ON hook
switch
.
! Preparation for using the Handsfree system
Before using the Hands-free system, it is
necessary to register a cell phone in the
system. Perform the following procedure
to register a cell phone.
NOTE
& Using the Hands-free system
! Turning on/off the Hands-free mode
. Up to 5 cell phones can be registered (for type A audio).
. Up to 6 cell phones (including Bluetooth® audio devices) can be registered
(for type B audio).
. When the ignition switch is turned to
the “Acc” or “ON” position, the registered cell phone may be automatically
connected to the system.
! Registering by operating dial
“TUNE” dial:
Type A audio
1)
2)
3)
OFF hook switch
ON hook switch
Talk switch
To turn on the Hands-free mode, press the
OFF hook switch
. To turn off the
Type B audio
Select the menus by operating the “TUNE”
dial.
Type A audio:
1. Press the OFF hook switch
.
2. Select “ENGLISH”/“FRANÇAIS” by
operating the “TUNE” dial.
– “WELCOME!” will then be displayed.
3. Press the “TUNE” dial or the talk
switch
.
4. Select the “RECORD NAME” menu, or
press the talk switch
.
5. Say the name to be registered.
6. Select the “CONFIRM” menu.
– After “CAR M_MEDIA” is displayed,
a pass key will be displayed.
7. Input the displayed pass key into the
cell phone while “PKY: ****” is displayed.
Type B audio:
1. Press the OFF hook switch
.
– If no cell phone is registered,
“Welcome!!” is shown on the screen.
In this case, perform the procedure
after step 4.
2. Select the “Setup” menu.
3. Select the “Phone Setup” menu.
4. Select the “Pair Phone” menu.
5. Select the “Record Name” menu.
6. Say the name to be registered.