3-30
Instruments and controls
& Security indicator light
This indicator light shows the status of the
alarm system. It also indicates operation
of the immobilizer system.
! Alarm system
It blinks to show the driver the operational
status of the alarm system. For detailed
information, refer to “Alarm system” F225.
! Immobilizer system
The light deters potential thieves by
indicating that the vehicle is equipped with
an immobilizer system. It begins flashing
under the following conditions.
For models with “keyless access with
push-button start system”:
. Immediately after the push-button ignition switch is turned to the “OFF” position.
. Immediately after any door is opened
when the push-button ignition switch is in
the “Acc” or “ON” position.
For models without “keyless access
with push-button start system”:
. Approximately 60 seconds after the
ignition switch is turned from th e “ON”
position to the “Acc” or “LOCK” position.
. Immediately after the key is pulled out.
If the indicator light does not flash, it may
indicate that immobilizer system may be
malfunctioning. Contact your nearest
SUBARU dealer immediately.
& Select lever/gear position indicator
In the event that an unauthorized key (for
example, an unauthorized duplicate) is
used, the security indicator light illuminates.
NOTE
Even if the security indicator light
flashes irregularly or its fuse blows
(the light does not flash if its fuse is
blown), the immobilizer system will
function normally.
Type A
1) Upshift/downshift indicator