3-8
Instruments and controls
! Type B combination meter
*1: “ ” or “ ” and “
” or “
” cannot
be displayed when the ignition switch is
in the “ON” position.
*2: MT models only
& Odometer
3. To change the current setting, press
the trip knob for at least 2 seconds.
: Activated
: Deactivated
NOTE
1. Turn the ignition switch to the “LOCK”/
“OFF” or “Acc” position.
2. Press the trip knob to show “ ” or
“ ” on the trip meter display.
The display can be switched as shown in
the following illustration by pressing the
trip knob.
. Your vehicle’s initial movement
setting of the meter/gauge needles
has been set for activation “ ” at
the time of shipment from the factory.
. It is not possible to change the initial
movement setting of the meter/gauge
needles when the ignition switch is in
the “ON” position. Change the setting
when the ignition switch is in the
“LOCK”/“OFF” or “Acc” position.
Type A
1) U.S. spec. models
2) Except U.S. spec. models
& Speedometer
The speedometer shows the vehicle
speed.
Type B
This meter displays the odometer when