2-30
Keys and doors
activation.
To enter the valet mode, change the
setting of your vehicle’s alarm system for
deactivation mode. Refer to “Activating
and deactivating the alarm system” F226. The security indicator light will continue to flash once every 3 seconds
indicating that the system is in the valet
mode.
To exit valet mode, change the setting of
your vehicle’s alarm system for activation
mode. Refer to “Activating and deactivating the alarm system” F2-26.
& Passive arming (models
without “keyless access with
push-button start system”)
When passive arming mode has been
programmed by the dealer, arming of the
system is automatically accomplished
without using the access key/remote
transmitter. Note that in this mode,
DOORS MUST BE MANUALLY LOCKED.
! To enter the passive mode
If you wish to program the passive arming
mode, have it done by your SUBARU
dealer.
! Arming the system
CAUTION
In passive mode, the system will
automatically activate the alarm but
WILL NOT automatically lock the
doors. In order to lock the doors
you must either lock them as indicated in step 4 below or with the
key once they have been closed.
Failure to lock the doors manually
will result in a higher security risk.
1. Turn the ignition switch to the “ON”
position.
2. Turn the ignition switch from “ON” to
“LOCK”/“OFF” position (all models) and
remove the key from the ignition switch
(models without “keyless access with
push-button start system”).
3. Open the doors and get out of the
vehicle.
4. Before closing the doors, lock all doors
with the inside door lock levers.
5. Close the doors. The system will
automatically arm after 1 minute.
In the passive mode, the system can also
be armed with the remote transmitter,
access key, keyless access function or
the power door locking switch. If the
remote transmitter, access key, keyless
access function or power door locking
switch is used to lock the vehicle, arming
will take place immediately regardless of
whether or not the passive mode has
been selected.
! Disarming the system
To disarm the system, briefly press the
disarm button on the access key/transmitter.