How to Operate Portable Audio Devices
• For vehicles sold in Canada
IC: 2024B-FT0036A
- English:
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
- Français:
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le
fonctionnement.
CAUTION: Radio Frequency Radiation Exposure
This equipment complies with IC radiation exposure limits set forth
for uncontrolled equipment and meets RSS-102 of the IC radio
frequency (RF) Exposure rules. This equipment has very low levels of
RF energy that it deemed to comply without maximum permissive
exposure evaluation (MPE). But it is desirable that it should be
installed and operated with at least 20cm and more between the
radiator and person's body (excluding extremities: hands, wrists, feet
and ankles).
270 Audio and Visual
CAUTION
• The frequency band used by this unit is the same band that
is used by industrial, scientific and medical devices such as
microwave ovens, facility wireless stations used for
identifying moving objects in factory production lines and
other locations (wireless station that requires a license),
special low output wireless stations (wireless station that
does not require a license), and amateur radios (wireless
station that requires a license). (The 3 types of wireless
stations above are hereafter called “other wireless
stations”.) Before operating this unit, make sure that no
“other wireless stations” are operating nearby. If the unit
causes harmful radio wave interference in “other wireless
stations”, immediately change the location to stop the radio
wave interference.
• The frequency band used by this unit is the 2.4 GHz band.
• The FH-SS modulation scheme is used.
• The estimated distance in which interference may occur is
less than 10 m.
• This unit uses the full band, making it possible to avoid the
band of devices that identify moving objects.
• This unit complies with the standards specified by the Radio
Act and Telecommu