7-12
Starting and operating
remote keyless entry transmitter will disarm the alarm system. Refer to “Alarm
system” F2-15.
2. Enter the vehicle.
3. The engine will shut down when any
door or trunk/rear gate is opened.
4. Insert the key into the ignition switch
and turn to the “START” position to restart
the engine.
& Remote start confirmation
transmitter feature
Your remote engine start transmitter is
equipped with a unique bidirectional confirmation feature. This feature will allow
the transmitter’s backlit button to display
the status of the system under the condition that the vehicle and transmitter are
within the operational range of the system.
Typical transmitter button flash sequences
are outlined in the following chart.
Transmitter flash sequence
Feature description
Flashes when button is
pressed
Indicates that the system is transmitting an RF signal.
Two long flashes following remote start activation (transmitter button is pressed two times
within 3 seconds)
Indicates that the transmitter did not receive the remote start
activation confirmation from the vehicle system. The transmitter
will automatically send one additional remote start activation
attempt. This usually occurs when the operational range is at its
limit or has been exceeded.
One flash following remote
start activation