Audio
operation, disconnect the connection
cable from the iPod® and reset it. For
the resetting procedure, see the User’s
Guide of the iPod®.
. If an iPod® and the connection cable
are connected improperly, the iPod®
cannot be powered on or will not be
recognized by in-vehicle equipment. In
this case, disconnect the connection
cable from the iPod®, and then connect
it again.
& How to play back
NOTE
. Depending on the number of files
stored on the iPod® and the firmware
version, the iPod® may not activate
smoothly after operation or not work
properly.
. Do not disconnect the connector
from the iPod® during iPod® operation.
! Type B audio
1. Connect a USB storage device/iPod®.
2. Press the
button. Each time you
briefly press the button, the mode
changes as follows.
The USB connector is located in the
center console. Use the connector to
connect a USB storage device/iPod®.
When the USB/iPod® mode is selected,
the player will start playback of the USB
storage device/iPod®.
! Type C audio
! When a USB storage device/iPod® is
not connected
Connect a USB storage device/iPod®.
Then the player will start playback of the
USB storage device/iPod®.
5-35
! When a USB storage device/iPod® is
already connected
Press the
button. Each time you
briefly press the button, the mode
changes as follows.
When the USB/iPod® mode is selected,
the player will start playback of the USB
storage device/iPod®.
& To select a track from the
beginning
Select a track in the same way as for a
CD. For details, refer to “To select a track
from the beginning” F5-24.
& To select a chapter from the
beginning when connecting
iPod®
When playing podcasts or audiobooks,
select a chapter in the same way as for a
CD. For details, refer to