Audio
. If you drive under a bridge
. If you are driving next to a tall vehicle
(such as a truck or a bus) that blocks the
signal
. If you are driving in a valley where the
surrounding hills or peaks block the signal
from the south
. If you are driving on a mountain road
where the southern direction is blocked by
mountains
unforeseen circumstances when there
are problems with the reception of XMTM
satellite radio signals.
& Band selection
& Displaying satellite radio ID
of tuner
When you activate satellite radio, you
should have your satellite radio tuner ID
ready because each tuner is identified by
its unique satellite radio tuner ID.
The satellite radio ID will be needed when
you activate satellite radio and receive
satellite radio customer support.
The satellite radio ID can be found on the
audio display by tuning the channel to
“000”.
Turn the “TUNE/TRACK/CH” dial to select
the satellite radio channel.
NOTE
. If you are driving in an area with tall
trees that block the signal (10 m or more),
for example on a road that goes through a
dense forest
. The signal can become weak in some
areas that are not covered by the repeater
station network.
5-15
Press the “SAT” button when the radio is
off to turn on the radio.
Press the “SAT” button when the radio is
on to select SAT1, SAT2 or SAT3 reception.
For Sirius, change the display to an
indication mode other than the channel
number after performing the above
operation.
Please note that these may be other
– CONTINUED –