Instruments and controls
warning light/malfunction indicator lamp
turn off immediately. It may take several
driving trips. If the light does not turn off,
take your vehicle to your authorized
SUBARU dealer immediately.
! If the light is blinking
If the light is blinking while driving, an
engine misfire condition has been detected which may damage the emission
control system.
To prevent serious damage to the emission control system, you should conform
to the following instructions.
. Reduce vehicle speed.
. Avoid hard acceleration.
. Avoid steep uphill grades.
. Reduce the amount of cargo, if possible.
. Stop towing a trailer as soon as
possible.
The CHECK ENGINE warning light/malfunction indicator lamp may stop blinking
and illuminate steadily after several driving trips. You should have your vehicle
checked by an authorized SUBARU dealer immediately.
& Coolant temperature
low indicator light/Coolant temperature high
warning light
CAUTION
. After turning the ignition switch
to the “ON” position, if this
indicator light/warning light behaves under any of the following
conditions, the electrical system
may be malfunctioning. Contact
your SUBARU dealer immediately for an inspection.
– It remains blinking in RED.
– It remains illuminated in RED
for more than 2 seconds.
– It remains blinking in RED and
BLUE alternately.
. While driving, if this indicator
light/warning light behaves under
any of the following conditions,
take the specified appropriate
measure listed below.
– Blinking in RED:
Decelerate the vehicle. After
the blinking RED light turns
off, you can drive the vehicle
normally.
– Illuminated in RED:
3-13
Safely stop the vehicle as
soon as possible, and refer
to the emergency steps for the
case of engine overheating.
After that, have the system
checked by your nearest
SUBARU dealer. Refer to “Engine overheating” F9-12.
– Blinking in RED and BLUE
alternately:
The electrical system may be
malfunctioning. Contact your
SUBARU dealer for an inspection.
This coolant temperature low indicator
light/coolant temperature high warning
light has the following three functions.
. Illumination in BLUE indicates insufficient warming up of the engine
. Blinking in RED indicates that the
engine is close to overheating
. Illumination in RED indicates overheating condition of the engine
For the system check, this indicator light/
warning light illuminates in RED for
approximately 2 seconds when the ignition switch is turned to the “ON” position.
After that, this indicator light/warning light
changes to BLUE and maintains illumination in BLUE. This BLUE illuminated light
– CONTINUED –