Keys and doors
sary to program the transmitter’s code
(identification number) into the system. A
tag showing the code is affixed to the key
unit, and another is affixed to the circuit
board inside the transmitter. If there is no
tag, open the transmitter case and make a
note of the eight-digit number. Program
the number into the system in accordance
with the following procedure.
1. Firmly close the doors and the rear
gate (Outback) or trunk lid (Legacy).
2. Open the driver’s door, sit in the
driver’s seat, and close the door.
3. Perform the following steps within 45
seconds.
2-13
NOTE
. When part 4 of the procedure is
completed, an electronic tone will
sound for 30 seconds.
. If you do not perform the operations
in part 4 within 15 seconds, an error
will occur and the electronic tone will
not sound. In this event, perform the
registration steps again beginning with
part 3 of the procedure.
1)
2)
LOCK
ON
(2) Insert the key into the ignition
switch, then turn it from the “LOCK”
position to the “ON” position 10 times
within 15 seconds.
NOTE
. When you complete step (2), an
electronic tone will sound once.
. If you do not perform steps (1) and
(2) within 45 seconds, an error will
occur. An electronic tone will not
sound. In this event, perform the whole
procedure again beginning with part 1.
(1) Open and close the driver’s door
once.
4. Open and close the door once within
15 seconds.
5. Before the electronic tone stops
sounding, press the lock side of the power
door lock switch the same number of
times as the leftmost digit of the transmitter code. For example, press the lock
switch eight times if the leftmost digit of
the code is 8.
– CONTINUED –