Subaru Legacy Manuals 2010 Legacy Owner's Manual | Page 369

Maintenance and service Check the fluid level on the outside of the reservoir. If the level is below “MIN”, add the recommended brake fluid to “MAX”. Use only brake fluid from a sealed container. & Recommended brake fluid FMVSS No. 116, fresh DOT 3 or 4 brake fluid CAUTION Never use different brands of brake fluid together. Also, avoid mixing DOT 3 and DOT 4 brake fluids even if they are the same brand. Clutch fluid (MT models) & Checking the fluid level WARNING Never let clutch fluid contact your eyes because clutch fluid can be harmful to your eyes. If clutch fluid gets in your eyes, immediately flush them thoroughly with clean water. For safety, when performing this work, wearing eye protection is advisable. 11-31 . Never splash the clutch fluid over painted surfaces or rubber parts. Alcohol contained in the clutch fluid may damage them. . Be careful not to spill clutch fluid when adding it. If clutch fluid touches the exhaust pipe, it may cause a bad smell, smoke, and/or a fire. If clutch fluid gets on the exhaust pipe, be sure to wipe it off. CAUTION . Clutch fluid absorbs moisture from the air. Any absorbed moisture can cause improper clutch operation. . If the vehicle requires frequent refilling, there may be a leak. If you suspect a problem, have the vehicle checked at your SUBARU dealer. . Never use different brands of clutch fluid together. . When clutch fluid is added, be careful not to allow any dirt into the tank. 1) 2) “MAX” level mark “MIN” level mark Check the fluid level on the outside of the reservoir. If the level is below “MIN” level mark, add the recommended clutch fluid to “MAX” level mark. – CONTINUED –