|
8. The system will exit the transmitter learn mode if the key is turned to the“ LOCK”/“ OFF” position, the door is closed or after 2 minutes.
& System Maintenance s07az09
NOTE
For remote engine starter transceiver:
In the event that the vehicle’ s battery is replaced, discharged or disconnected, it will be necessary to start the vehicle a minimum of one time using the key prior to activating the remote engine start system. This is required to allow the vehicle electronic systems to resynchronize.
|
! Changing the battery
CAUTION
s07az0901
. Do not let dust, oil or water get on or in the remote engine start transmitter when replacing the battery.
. Be careful not to damage the printed circuit board in the remote engine start transmitter when replacing the battery.
. Be careful not to allow children to touch the battery and any removed
|
parts; children could swallow them.
. There is a danger of explosion if an incorrect replacement battery is used. Replace only with the same or equivalent type of battery.
. Battery should not be exposed to excessive heat such as sunshine, fire or the like.
For models with“ keyless access with push-button start system”:
Perform the procedure described in“ Replacing Battery of Access Key Fob” FP472.
For remote engine starter transceiver:
The 3-volt lithium battery( model CR-2450) supplied in your remote engine start transmitter should last approximately one year, depending on usage. When the battery begins to weaken, you will notice a decrease in range( distance from the vehicle that your remote control operates). Follow the instructions below to change the remote engine start transmitter battery.
|
1. Remove the small phillips screw located on the back side lower left corner of the transmitter.
2. Carefully pry the remote engine start transmitter halves apart using a small flat-head screwdriver.
|
7
Starting and Operating
|
||||
– CONTINUED – |