132
Alarm System
system will enter surveillance state.
When the system is in surveillance state, the security indicator light will then flash slowly( twice approximately every 2 seconds), indicating that the system has been armed for surveillance.
NOTE
. The system can be armed even if the windows and / or moonroof are open. Always make sure that they are fully closed before arming the system.
. The 30-second standby time can be eliminated if you prefer. Have it performed by your SUBARU dealer.
. If any of the following actions is done during the standby period, the system will not switch to the surveillance state. – Doors( including the rear gate) are unlocked using the access key fob / remote transmitter.
– Doors( including the rear gate) are unlocked using the keyless access function( models with“ keyless access with push-button start system”).
– Any door( including the engine hood) is opened.
– The ignition switch is turned to the“ ON” position( models without“ keyless access with pushbutton start system”).
– Push-button ignition switch is turned to the“ ACC” position( models with“ keyless access with push-button start system”).
& Disarming the System s02af05
Perform either of the following procedures.
. Briefly press an unlock button( for less than 2 seconds) on the access key fob / remote transmitter.
. Carry the access key fob and perform either of the following procedures( models with“ keyless access with push-button start system”). – Grip the front door handle. – Press the rear gate opener button. – Unlock using the PIN Code Access.
The flashing of the security indicator light will then change slowly( once approximately every 3 seconds from twice approximately every 2 seconds), indicating that the alarm system has been disarmed.
! Emergency disarming s02af0501
If you cannot disarm the system using the access key fob / transmitter( i. e., the transmitter is lost, broken or the transmitter battery is too weak), you can disarm the system without using the access key fob / remote transmitter.
The system can be disarmed if you turn the ignition switch from the“ LOCK”/“ OFF” position to the“ ON” position with a registered key / access key fob.
NOTE
For models with“ keyless access with push-button start system”, if the access key fob battery is discharged, perform the procedure described in“ Switching Power Status” FP412. In such a case, replace the battery immediately. Refer to“ Replacing Battery of Access Key Fob” FP472.
& Alarm System Setting s02af11
To change the setting of your vehicle’ s alarm system for activation or deactivation, do the following.
1. Disarm the alarm system. Refer to“ Disarming the System” FP132.
2. Sit in the driver’ s seat and shut all doors, the rear gate and engine hood.
3. Turn the ignition switch to the“ ON” position.
4. Hold down“” of the driver’ s power door locking switch, open the driver’ s door within the following 1 second, and wait 10 seconds without releasing the switch. The setting will then be changed as follows.