INTRODUCTION
NOTE
� The screen may be adversely affected or disturbed by noise if electrical equipment that generates powerful electrical noise is used near the system. In such cases, keep the electrical equipment at a distance, or refrain from use.
� The display may appear brighter when the temperature is low, or immediately after starting the engine, however, this is a characteristic of the LED elements, and does not indicate a fault. The display will return to its original brightness when the vehicle cabin has warmed up.
� When you look at the screen through polarized material such as polarized sunglasses, the screen may be dark and hard to see. If so, look at the screen from different angles, adjust the screen settings on the general settings screen or take off your sunglasses.
� It may be difficult to view the screen if the display is exposed to sunlight from an awkward angle.
� The LCD screen may not function normally if covered with a protective film. Do not affix a protective film.
� The touch panel may function incorrectly or fail to respond if operated with objects other than fingers( nails, operation when wearing gloves, pens, etc.)
� If the system functions unexpectedly such as an area other than the one touched being selected, or failure to respond when touched, there is a possibility that another finger or part of the hand is in contact with display.
� Scratches on the system panel surface are easily noticeable, and it should therefore be handled with care.
� If a device that uses wireless communication is installed in the vehicle, functions using a Bluetooth device, the radio broadcast receiver, navigation system, etc. may not operate properly.
WHEN TRANS VEHICLE
CAUTION
� When transferrin information reg Data Reset. For“ GENERAL SETT
Note that certa and the phone n data logs even strictly for qual subsequent pur from the vehicle
8