|
less access function may not operate properly.
. When the access key fob is within the operating range, it is possible for anyone, even someone who is not carrying the access key fob, to operate the keyless access function. Note that the keyless access function can be operated only by the door handle, door lock sensor or rear gate opener button in the operating range in which the access key fob is detected.
. It is not possible to lock the doors, the rear gate and the fuel filler lid using the keyless access function when the access key fob is inside the vehicle. However, depending on the status of the access key fob and the environmental conditions, the access key fob may be locked inside the vehicle. Before locking the vehicle, make sure that you have the access key fob.
. When the battery of the access key fob is discharged, or when operating it in a location with strong radio waves or noise( e. g., near a radio tower, power plant, broadcast station or an area where wireless equipment is used), or while talking on a cell phone, the operating ranges may be reduced, or the keyless
|
access function may not operate. In such a case, perform the procedure described in“ Locking and Unlocking” FP426.
. The doors may lock or unlock when the car is being washed or exposed to a significant amount of water that touches the door handle while the key fob is still in the operating range.
! How to lock and unlock s02ap0108
It is possible to perform the following operations when you are carrying the access key fob.
. Lock and unlock the doors and the fuel filler lid.
. Lock and unlock the rear gate.
NOTE
. It is not possible to lock the doors, the rear gate and the fuel filler lid using the keyless access function when the push-button ignition switch is in the“ ACC” or“ ON” position. Refer to“ Switching Power Status” FP149.
. If the door handle is gripped with a gloved hand, the door lock may not be released.
. If the door lock sensor is touched four times or more repeatedly, the system will ignore the sensor operation
|
.
. When performing the locking procedure too quickly, locking may not complete. After performing the locking procedure, it is recommended to pull the rear door handle to confirm that the doors have been locked.
. If any of the doors( including the rear gate) is not fully closed, the following will occur to alert you. – An electronic chirp sounds five times. – The hazard warning flashers flash five times.
. If any of the doors or the rear gate is open, the doors, the rear gate and the fuel filler lid cannot be locked.
. Within 3 seconds after locking the doors and the rear gate using the keyless access function, it is not possible to unlock the doors and / or the rear gate using the keyless access function.
. When locking, be sure to carry the access key fob to prevent locking the access key fob in the vehicle.
. The setting of the hazard warning flasher operation can be changed by operating the center information display. For details, refer to“ Car settings” FP201( 11.6-inch display models) or“ Vehicle setting icons”
|
2
Keys and Doors
|
– CONTINUED – |