310
Starting and Stopping the Engine ( Models without Push-Button Ignition Switch )
CAUTION
. If the engine is stopped during driving , the catalyst may overheat and burn .
. When starting the engine , be sure to sit in the driver ’ s seat ( except when using the remote engine start system ).
NOTE
. Avoid racing and rapid acceleration immediately after the engine has started .
. After the engine starts , the engine speed will be kept high .
. On rare occasions , it may be difficult to start the engine depending on the fuel used and the driving condition ( repeated short trips when the engine is not warmed up sufficiently ). In such a case , it is recommended to switch to a different brand of fuel .
. On rare occasions , transient knocking may be heard from the engine when the accelerator is operated rapidly such as a rapid start-up and a rapid acceleration . This is not a malfunction .
. The engine starts more easily when the headlights , air conditioner and rear window defogger are turned off .
& Starting Engine
CAUTION s07bd01
Do not operate the engine starter continuously for more than 10 seconds . If the engine fails to start after operating the engine starter for 5 to 10 seconds , wait for 10 seconds or more before trying again .
NOTE
. It may be difficult to start the engine when the battery has been disconnected and reconnected ( for maintenance or other purposes ). This difficulty is caused by the electronically controlled throttle ’ s self-diagnosis function . To overcome it , keep the ignition switch in the “ ON ” position for approximately 10 seconds before starting the engine . . Do not shift the select lever while the engine starter is cranking .
CAUTION
If you restart the engine while the vehicle is moving , shift the select lever into the “ N ” position . Do not attempt to place the select lever of a moving vehicle into the “ P ” position .
1 . Apply the parking brake .
2 . Turn off unnecessary lights and accessories .
3 . Shift the select lever to the “ P ” or “ N ” position ( preferably “ P ” position ). The engine starter will only operate when the select lever is at the “ P ” or “ N ” position .
4 . Turn the ignition switch to the “ ON ” position and check the operation of the warning and indicator lights . Refer to “ Warning and Indicator Lights ” FP152 .
5 . Turn the ignition switch to the “ START ” position without depressing the accelerator pedal . Release the key immediately after the engine has started . If the engine does not start , perform the following procedure . ( 1 ) Turn the ignition switch to the “ LOCK ” position and wait for at least 10 seconds . After checking that the parking brake is applied , turn the ignition switch to the “ START ” position while depressing