INTRODUCTION
NOTE
� The screen may be adversely affected or disturbed by noise if electrical equipment that generates powerful electrical noise is used near the system . In such cases , keep the electrical equipment at a distance , or refrain from use .
� The display may appear brighter when the temperature is low , or immediately after starting the engine , however , this is a characteristic of the LED elements , and does not indicate a fault . The display will return to its original brightness when the vehicle cabin has warmed up .
� When you look at the screen through polarized material such as polarized sunglasses , the screen may be dark and hard to see . If so , look at the screen from different angles , adjust the screen settings on the general settings screen or take off your sunglasses .
� It may be difficult to view the screen if the display is exposed to sunlight from an awkward angle .
� The LCD screen may not function normally if covered with a protective film . Do not affix a protective film .
� The touch panel may function incorrectly or fail to respond if operated with objects other than fingers ( nails , operation when wearing gloves , pens , etc .)
� If the system functions unexpectedly such as an area other than the one touched being selected , or failure to respond when touched , there is a possibility that another finger or part of the hand is in contact with display .
� Scratches on the system panel surface are easily noticeable , and it should therefore be handled with care .
� If a device that uses wireless communication is installed in the vehicle , functions using a Bluetooth device , the radio broadcast receiver , navigation system , etc . may not operate properly .
WHEN TRANS VEHICLE
CAUTION : When transferrin personal informat a Factory Data Re refer to the “ GENER
Note that certain and the phone n vehicle data logs logs are strictly fo by any subseque permanently from dealer .
8