Starting and operating / Starting and stopping engine ( models with push-button start system ) 7-13
more than 10 seconds . Doing so could cause a malfunction . If the engine does not start , stop pushing the push-button ignition switch . Instead , press the pushbutton ignition switch without depressing the brake pedal to switch the power status to “ OFF ”. Wait 10 seconds , and then push the push-button ignition switch to start the engine .
NOTE
. After the engine starts , the engine speed will be kept high . . When the push-button ignition switch is pressed while depressing the clutch pedal ( MT models ) or the brake pedal ( CVT models ), the engine starter operates for a maximum of 10 seconds and after starting the engine , the starter stops automatically . . When the push-button ignition switch is pressed while depressing the clutch pedal ( MT models ) or the brake pedal ( CVT models ), the engine can be started regardless of the status of the push-button ignition switch . . If the security indicator light illuminates when you attempt to start the engine but the engine does not start , press the push-button ignition switch to switch the power to “ OFF ” and then try to start the engine again . . If the engine does not start , press the push-button ignition switch without depressing the clutch pedal ( MT models ) or the brake pedal ( CVT models ) to switch the power to “ OFF ”. Then , while depressing the clutch pedal ( MT models ) or the brake pedal ( CVT models ) more forcefully , press the push-button ignition switch . . The engine start procedures may not function depending on the radio wave conditions around the vehicle . In such a case , refer to “ Starting engine ” F9- 20 . . If the vehicle battery is discharged , the steering cannot be unlocked . Charge the battery . . Do not shift the select lever ( CVT models ) or shift lever ( MT models ) while the starter is cranking .
1 ) Operation indicator 2 ) Push-button ignition switch
When the push-button ignition switch is pressed while depressing the clutch pedal ( MT models ) or the brake pedal ( CVT models ), the engine will start . The starting procedure for the engine is as follows .
! MT models
S07BE0301
1 . Carry the access key fob , and sit in the driver ’ s seat .
2 . Apply the parking brake . 3 . Shift the shift lever in neutral . 4 . Depress the brake pedal .
5 . Depress the clutch pedal until the indicator on the push-button ignition switch turns green .
6 . While depressing the clutch pedal , press the push-button ignition switch .
– CONTINUED –