Keys and doors/Alarm system
. If any of the following actions is
done during the standby period, the
system will not switch to the surveil-
lance state.
– Doors (including the rear gate/
trunk lid) are unlocked using the
access key fob/remote transmitter.
– Doors (including the rear gate/
trunk lid) are unlocked using the
keyless access function (models
with “keyless access with push-
button start system”).
– Any door (including the rear gate/
trunk lid) is opened.
– The ignition switch is turned to
the “ON” position (models without
“keyless access with push-button
start system”).
– Push-button ignition switch is
turned to the “ACC” position (mod-
els with “keyless access with push-
button start system”).
– Grip the front door handle.
– Press the rear gate opener button
(5-door models).
– Unlock using the PIN code access.
The flashing of the security indicator light
will then change slowly (once approxi-
mately every 3 seconds from twice ap-
proximately every 2 seconds), indicating
that the alarm system has been disarmed.
! Emergency disarming
S02AF0501
If you cannot disarm the system using the
access key fob/transmitter (i.e. the trans-
mitter is lost, broken or the transmitter
battery is too weak), you can disarm the
system without using the access key fob/
remote transmitter.
The system can be disarmed if you turn the
ignition switch from the “LOCK”/“OFF” to
the “ON” position with a registered key/
access key fob.
NOTE
& Disarming the system
S02AF05
Perform either of the following procedures.
. Briefly press a button (for less than 2
seconds) on the access key fob/remote
transmitter.
. Carry the access key fob and perform
either of the following procedures (models
with “keyless access with push-button
start system”).
For models with “keyless access with
push-button start system”, if the ac-
cess key fob battery is discharged,
perform the procedure described in
“Switching power status” F9-19. In
such a case, replace the battery im-
mediately. Refer to “Replacing battery
of access key fob” F11-46.
2-29
& Alarm system setting
S02AF11
To change the setting of your vehicle’s
alarm system for activation or deactiva-
tion, do the following.
1. Disarm the alarm system. Refer to
“Disarming the system” F2-29.
2. Sit in the driver’s seat and shut all
doors and the rear gate (5-door models).
3. Turn the ignition switch to the “ON”
po sition.
4. Hold down the unlock side of the
driver’s power door locking switch, open
the driver’s door within the following 1
second, and wait 10 seconds without
releasing the switch. The setting will then
be changed as follows.
. Type A combination meter
Setting
status
Combination
meter display
Horn
Activate AL on Once
Deactivate AL oF Twice
. Type B combination meter
Setting
status
Combination
meter display
Horn
Activate AL ON Once
Deactivate AL OFF Twice
– CONTINUED –