3-68
Instruments and controls/Light control switch
& High/low beam change
(dimmer)
& Headlight flasher
& High beam assist function (if
equipped)
NOTE
. The high beam assist function uti-
lizes the stereo camera installed at the
position of the front map lights.
. For details on how to handle the
stereo camera, refer to the Owner’s
Manual supplement for the EyeSight
system.
The high beam assist function automati-
cally changes the headlight from high
beam to low beam (or vice versa).
1)
2)
High beam
Low beam
When the headlights are on high beam,
the high beam indicator light “ ” on the
combination meter is also on.
CAUTION
Do not hold the lever in the flashing
position for more than just a few
seconds.
To flash the headlights, pull the lever
toward you and then release it. The high
beam will stay on for as long as you hold
the lever.
When the headlights are on high beam,
the high beam indicator light “ ” on the
combination meter also illuminates.
When all of the following conditions are
met, the headlight will change to high
beam.
. When the vehicle speed increases to
or above 20 mph (32 km/h).
. There is no preceding or oncoming
vehicle.
. The forward area of the vehicle is dark.
. The road does not have a sharp curve.
When any of the following conditions is
met, the headlight will change to low
beam.
. When the vehicle speed decreases to
or below 10 mph (16 km/h).
. When the forward area of the vehicle is
bright.