Keys and doors/Alarm system
& Alarm system setting
NOTE
To change the setting of your vehicle’s
alarm system for activation or deactiva-
tion, do the following.
1. Disarm the alarm system. Refer to
“Disarming the system” F2-28.
2. Sit in the driver’s seat and shut all
doors and the rear gate (5-door models).
3. Turn the ignition switch to the “ON”
position.
4. Hold down the unlock side of the
driver’s power door locking switch, open
the driver’s door within the following 1
second, and wait 10 seconds without
releasing the switch. The setting will then
be changed as follows.
. Type A combination meter
Setting
status
Combination
meter display
Horn
AL on Once
Deactivate AL oF Twice
. Type B combination meter
Combination
meter display
& If you have accidentally trig-
gered the alarm system
! To stop the alarm
Do any of the following operations:
. Press any button on the access key
fob/remote transmitter.
. Turn the ignition switch to the “ON”
position (models without “keyless access
with push-button start system”).
. Turn the push-button ignition to the
“ACC” position (models with “keyless
access with push-button start system”).
NOTE
Activate
Setting
status
You may have the above setting
change done by your SUBARU dealer.
Horn
Activate ALON Once
Deactivate ALOF Twice
Only registered keys will stop the
alarm. If the immobilizer transponder
is not registered, the alarm will not
stop.
2-29
& Valet mode
When you choose the valet mode, the
alarm system does not operate. In valet
mode, the remote transmitter is used only
for locking and unlocking the doors and
rear gate (5-door models) and panic
activation.
To enter the valet mode, change the
setting of your vehicle’s alarm system for
deactivation mode. Refer to “Alarm sys-
tem setting” F2-29. The security indicator
light will continue to flash once every 3
seconds indicating that the system is in
the valet mode.
To exit valet mode, change the setting of
your vehicle’s alarm system for activation
mode. Refer to “Alarm system setting”
F2-29.