Instruments and controls/Multi function display
2. Operate the “ ” or “ ” switch to
select the “Defogger” item. Then push the
button.
4. Select the preferred setting by operating the “ ” or “ ” switch. Then push the
button.
3. The current setting will be displayed.
Push the
button to enter the selection
mode.
5. Select “Set” by operating the “ ”
switch, and confirm the setting by pushing
the
button.
3-81
6. The system will notify you that the
setting is complete.
If the setting is not available, the following
notification will be displayed. In this case,
perform the setting procedure again.
– CONTINUED –