Subaru Impreza Manuals 2014 Impreza Owner's Manual | Page 311

7-14 Starting and operating/Remote engine start system (dealer option) Transmitter flash sequence Feature description Flashes when button is pressed Indicates that the system is transmitting an RF signal. Two long flashes following remote start activation (transmitter button is pressed two times within 3 seconds) Indicates that the transmitter did not receive the remote start activation confirmation from the vehicle system. The transmitter will automatically send one additional remote start activation attempt. This usually occurs when the operational range is at its limit or has been exceeded. One flash following remote start activation (transmitter button is pressed two times within 3 seconds) Indicates that the engine is running via remote start. If the transmitter is moved outside of the operating range of the system, this sequence will timeout after the normal 15-minute vehicle run cycle. 2 flashes every 5 seconds Indicates that the engine is running via remote start. If the transmitter is removed outside of the operating range of the system, this sequence will timeout after the normal 15-minute vehicle run cycle. 3 flashes Indicates that the engine has turned off due to a remote start system 15-minute timeout, vehicle safety parameter or normal shutdown. & Entering the vehicle following remote engine start shutdown An alarm trigger may occur if the vehicle is opened by the remote keyless entry transmitter within a few seconds immediately following remote engine start shutdown. & Pre-heating or pre-cooling the interior of the vehicle Models with automatic climate control system: After the system starts the engine, the automatic climate control system will activate the “FULL AUTO” mode and heat or cool the interior to the predetermined median (room) temperature. No presetting of controls is necessary. Models with manual climate control system: Before exiting the vehicle, set the temperature controls to the desired setting and operation. After the system starts the engine, the heater or air conditioning will activate and heat