Instruments and controls/Mirrors
3-83
NOTE
NOTE
. After programming your HomeLink®
Wireless Control System for the desired devices, retain the hand-held
transmitters for further programming
or device testing in the event of a
problem.
. It is recommended that you insert a
new battery in the hand-held transmitter of a device to ensure correct
programming.
Some gate operators and garage door
openers may require you to replace
this programming step 4 with procedures in “Programming for entrance
gates and garage door openers in
Canada” F3-84.
! Garage door opener programming in the U.S.A.
NOTE
When programming the HomeLink®
Wireless Control System for a garage
door opener, it is suggested that you
park the vehicle outside the garage.
1. Unplug the motor of the garage door
opener from the outlet.
NOTE
If any of the HomeLink® buttons are
already programmed for other devices,
skip step 2 because it clears the
memory of all three buttons.
1)
2)
3)
HomeLink® button 1
HomeLink® button 2
HomeLink® button 3
2. Press and hold the two outer
HomeLink® buttons (button 1 and button
3) until the indicator light begins to flash
(after approximately 20 seconds). Then
release both buttons.
3. Hold the end of the garage door
opener’s hand-held transmitter between
1 and 3 inches (25 and 76 mm) away from
the HomeLink® button you wish to program.
4. Simultaneously press and hold both
the hand-held transmitter button and the
desired HomeLink® button. DO NOT release the buttons until step 5 has been
completed.
5. Hold down both buttons until the
HomeLink® indicator light flashes, first
slowly then rapidly. When the indicator
light flashes rapidly, both buttons may be
released. (The rapidly flashing light indicates successful programming of the new
frequency signal.)
6. Press and hold the programmed button and check the HomeLink® indicator
light. If the indicator light stays on continuously, your garage door should activate and the programming is completed.
If the indicator light flashes rapidly for 2
seconds and then stays on continuously,
your garage door opener may be protected by a rolling code feature. In this
case you need to perform the additional
steps that are described in “Programming
rolling-code-protected garage door openers in the U.S.A.” F3-84.
– CONTINUED –