3-76
Instruments and controls/Wiper and washer
. In freezing weather, be sure that
the wiper blades are not frozen to
the windshield or rear window
before switching on the wipers.
Attempting to operate the wiper
with the blades frozen to the
window glass could cause not
only the wiper blades to be
damaged but also the wiper motor to burn out. If the wiper
blades are frozen to the window
glass, be sure to operate the
defroster, windshield wiper deicer (if equipped) or rear window
defogger before turning on the
wiper.
. If the wipers stop during operation because of ice or some other
obstruction on the window, the
wiper motor could burn out even
if the wiper switch is turned off. If
this occurs, promptly stop the
vehicle in a safe place, turn the
ignition switch to the “LOCK”
(off) position and clean the window glass to allow proper wiper
operation.
. Use clean water if windshield
washer fluid is unavailable. In
areas where water freezes in
winter, use SUBARU Windshield
Washer Fluid or the equivalent.
Refer to “Windshield washer
fluid” F11-29.
Also, when driving the vehicle
when there are freezing temperatures, use non-freezing type wiper blades.
. Do not clean the wiper blades
with gasoline or a solvent, such
as paint thinner or benzine. This
will cause deterioration of the
wiper blades.
NOTE
. The windshield wiper motor is protected against overloads by a circuit
breaker. If the motor operates continuously under an unusually heavy load,
the circui B'&V