Instruments and controls
2. Operate the “ ” or “ ” switch to
select the “On/Off” item, and then pull the
“ /SET” switch toward you.
4. Select “On” or “Off” by operating the
“ ” or “ ” switch, and then pull the “ /
SET” switch toward you.
3-53
6. The system will notify you that the
setting is complete for approximately 3
seconds.
! Clear setting
1. Perform the preparation steps according to “Preparation for maintenance settings” F3-51.
3. The current setting is displayed. Pull
the “ /SET” switch toward you to enter
the selection mode.
5. Select “Set” by operating the “ ”
switch, and confirm the setting by pulling
the “ /SET” switch toward you.
– CONTINUED –