3-28
Instruments and controls
! Turn off display of driving information display
The driving information display can be
turned off.
To turn off the display, turn the ignition
switch to the “LOCK” position and press
the “+” button adjacent to the clock display
for approximately 5 seconds. Then, the
driving information display and the clock
display will blink for 3 seconds to notify
you that the driving information display
has been turned off.
To restore the driving information display,
once again press the “+” button for
approximately 5 seconds.
NOTE
. The initial display setting of the
driving information display has been
set to operational at the time of shipment from the factory.
. The average fuel consumption and
average vehicle speed are calculated
even while the driving information display is not displayed.
. Even if you turn off the driving
information display, the display will
automatically turn on when the battery
voltage is disconnected and then reconnected for battery replacement or
fuse replacement.
& Clock
To adjust the time shown by the clock,
press the “+” button or “−” button. If you
press the “+” button, the indicated time will
change in one-minute increments. If you
press the “−” button, the indicated time will
change in one-minute decrements. If you
keep the button pressed, the rate at which
the indicated time changes will speed up.
The clock can be set to 12-hour or 24-hour
clock displays. Perform the following
procedure to switch the display format.
1. Place the ignition switch in the “LOCK”
position.
2. Press and hold the “−” button that is
located near the clock display for approximately 5 seconds. The clock display will
then start to flash.
3. While the clock display is flashing,
press and hold the “+” button for approximately 2 seconds. The clock format will
then change.
4. The clock display will continue to flash
for approximately 3 seconds to inform you
that the clock display has been changed.
If you want to change the clock display
again, press and hold the “+” button for
approximately 2 seconds while the clock
display is flashing.