56
SEAT, SEATBELT AND SRS AIRBAGS
Rear center seating position s01ac0302
CAUTION
Incorrect( retracted position) Correct( extended position)
S _ 103214-MW
The head restraint is not intended to be used in the retracted position. Before sitting on the seat, raise the head restraint to the extended position.
To remove:
While pressing the release button, pull out the head restraint.
To install:
Install the head restraint into the holes that are located on the top of the seatback until the head restraint locks. Press and hold the release button to lower the head restraint.
When the rear-center seating position is occupied, raise the head restraint to the extended position. When the rear center seating position is not occupied, lower the head restraint to improve rearward visibility.
ARMREST( If Equipped) s01ac01
S _ 103065-W
To lower the armrest, pull the armrest’ s top edge.
Head restraint Release button
S _ 103215-W
To raise: Pull the head restraint up. To lower:
Push the head restraint down while pressing the release button on the top of the seatback.
WARNING
. Make sure to have the rear passengers wear the seatbelts before lowering the armrest. If the rear passengers wear the seatbelts after lowering the armrest, seatbelts cannot provide maximum restraint, causing serious injuries.
. To avoid serious injury, never allow passengers to sit on the center armrest while the vehicle is in motion.