Subaru Forester Manuals 2026 Forester Owner's Manual | Page 469

DRIVING TIPS 465
the drilled hole. Exhaust gas contains carbon monoxide, a colorless and odorless gas which is dangerous, or even lethal, if inhaled. Also, drilling the frame or under-body of your vehicle could cause deterioration of strength of your vehicle and cause corrosion around the drilled hole.
Front
S _ 801536-W
The tongue load can be adjusted by proper distribution of the load in the trailer. Never load the trailer with more weight in the back than in the front; approximately 60 percent of the trailer load should be in the front and approximately 40 percent in the rear. Also, distribute the load as evenly as possible on both the left and right sides.
Be sure that all cargo is firmly secured to prevent a change in weight distribution while driving.
WARNING
If the trailer is loaded with more weight in the back of trailer’ s axle than in the front, the load is taken off the rear axle of the towing vehicle. This may cause the rear wheels to skid, especially during braking or when vehicle speed is reduced during cornering, resulting in over-steer, spin out and / or jackknifing.
TRAILER HITCHES( Dealer Option) s08al03
WARNING
Never drill the frame or under-body of your vehicle to install a commercial trailer hitch. If you do, dangerous exhaust gas, water or mud may enter the passenger compartment through
CAUTION
. Do not modify the vehicle exhaust system, brake system, or other systems when installing a hitch or other trailer towing equipment.
. Do not use axle-mounted hitches as they can cause damage to the axle housing, wheel bearings, wheels or tires.
Do not use a trailer hitch other than a genuine SUBARU trailer hitch. A genuine SUBARU trailer hitch is available from your SUBARU dealer.
WHEN YOU DO NOT TOW A TRAILER s08al14
CAUTION
. The housing should be kept dirt and corrosion-free at the points of contact. The surfaces only require cleaning with a cloth. Grease or other lubricants should never be used.
. If the ball is not installed, the plastic insert and / or bumper cover should then be installed for protection and to prevent it from getting dirty.
When the ball is not used, place the ball cap and store securely.
8
– CONTINUED –