INTERIOR EQUIPMENT 323
. When your mobile device emits heat during charging, the mobile device’ s protective function may cancel charging.
. The fan may activate when the temperature rises, but this is not a malfunction.
. Qi standard wireless charger can be used on compatible devices. However, not all Qi standard devices and compatibility are guaranteed.
. If you hear noise on the AM radio while your device is charging, you may be able to reduce the noise by changing the charging frequency. To change the charging frequency, press and hold the power switch to turn on the system. After a certain amount of time, the indicator light will flash orange twice to indicate when the frequency changes.
. If the access key fob cannot be detected in the cabin, the battery cannot be charged. In addition, charging may be temporarily suspended when the remote keyless entry system is in operation, such as when opening and closing doors.
. In the following cases, the wireless charger will not operate normally:
– You are in an area near a facility where electronic equipment is emitting strong radio waves, such as a power plant, broadcast station, or TV tower, or an electronic remote controller is being used
nearby. – The ambient temperature around
the charging tray is high due to hot weather.
. If charging stops after a certain period of time, and the wireless charger does not operate normally, it may be due to any of the following reasons:
– The mobile device is protruding
from the charging area. – The mobile device is equipped with
a large protruding camera. – A thick object such as a case,
cover, or accessory is between the charging surface of the portable
device and the charging area. – Two or more mobile devices are
placed on the charging tray at the same time.
CERTIFICATION FOR THE WIRELESS CHARGER s06bh02
The U. S. and other FCC compliant countries:
FCC ID: ACJ932AF2201
CAUTION
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the user’ s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a wireless power charger, pursuant to part 18 of the FCC Rules.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio communications, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
6
– CONTINUED –